CA DMV Motorcycle Written Test – 3

July 26, 2026

Most collisions involve riders who:

(A) Overbrake the rear tire. (B) Underbrake the rear tire. (C) Were experienced riders.

Following a vehicle too closely:

(A) Protects you in heavy traffic. (B) Helps you see hazards in the road. (C) Is a factor in many motorcycle collisions.

In the situation shown, the car driver is preparing to enter the intersection. To be seen and maintain a space cushion, you should:

(A) Slow down and move away from the vehicle after entering the intersection. (B) Slow down and move closer to the curb so the driver can see you better. (C) Speed up to get through the intersection quickly, then move left.

Alcohol enters the bloodstream and quickly reaches the brain. Which ability is affected first?

(A) Speech. (B) Balance. (C) Judgment.

In the situation shown, riders A, B, and C are riding as a group. To pass, rider B should:

(A) Complete the pass in front of rider A. (B) Return to the lane and ride next to rider A. (C) Return to the right portion of the lane behind rider A.

You should make a special point to use your mirrors when:

(A) Riding through an intersection. (B) Following another vehicle. (C) Slowing down or stopping.

You plan to make a right turn after stopping at an intersection. Usually, you should begin the turn from:

(A) The left portion of the lane. (B) The center portion of the lane. (C) The right portion of the lane.

Failing to turn off your turn signal:

(A) May encourage other drivers to pull into your path. (B) Keeps other drivers from seeing your brake light. (C) Reduces your chances of a collision because other drivers stay clear.

If your front tire goes flat while riding, you should:

(A) Apply the rear brake and steer to the edge of the road. (B) Steer to the right and apply both brakes. (C) Accept that you will not be able to control the motorcycle.

When making a turn, you should:

(A) Keep your head and eyes straight ahead to maintain balance. (B) Look through the turn to where you want to go. (C) Always lean at the same angle as the motorcycle.

Riding in the center portion of the lane:

(A) Should be avoided whenever possible. (B) Makes it harder for other drivers to see you. (C) Discourages other vehicles from sharing your lane.

Wearing a DOT-compliant helmet will:

(A) Increase your chances of a head injury. (B) Reduce your chances of a head injury. (C) Have no effect on head injuries.

To reduce your speed before entering a turn, you should:

(A) Close the throttle and apply both brakes. (B) Pull in the clutch and use both brakes. (C) Apply only the rear brake.

To operate the throttle correctly, you should:

(A) Start with your wrist flat. (B) Sit forward with your arms completely straight. (C) Twist the throttle forward and down for more power.

When carrying loads on a motorcycle, you should:

(A) Keep the load low and as far forward as possible. (B) Keep the load toward the rear of the motorcycle. (C) Fasten the load only against the back of the seat.

When approaching a blind curve, you should:

(A) Ride as fast as possible before entering the curve. (B) Reduce your speed before entering the curve. (C) Move into the oncoming traffic lane for a better view.

The best way to improve your visibility to other drivers is to:

(A) Ride with your headlight on and wear bright or reflective clothing. (B) Sound your horn continuously while riding. (C) Ride close to other vehicles.

If you must ride over a metal grate or railroad tracks, you should:

(A) Cross at a safe speed and as close to a right angle as possible. (B) Brake hard while crossing. (C) Turn sharply while on the surface.

When riding in heavy traffic, your primary goal should be to:

(A) Maintain a space cushion around your motorcycle. (B) Stay as close as possible to the vehicle ahead. (C) Ride in drivers' blind spots.

Before starting your ride, you should always:

(A) Perform a pre-ride inspection of your motorcycle. (B) Warm up the engine for at least 15 minutes. (C) Check only the fuel level.

Test Result

Home